Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2.
Make sure that the seal inside the smaller
of the connecting pieces on the hose (13)
fits on to the dust extraction connection
(10).
3.
Turn the suction hose to the right until it
engages.
4.
Attach a suitable dust extraction device.
5.
Before each use, ensure that the lid (13a)
is attached to the adapter (13b).
Notes:
•
Make sure that the vacuum cleaner is
suitable for use with the electric power
tool. Most dry vacuum cleaners for
domestic use are well suited to this
purpose.
•
The vacuum cleaner is particularly useful if
many cuts are being performed succes-
sively. It means that less frequent stops
are required to clean the electric power
tool and the workplace.
•
When you are cutting materials which may
produce dangerous dust, always use a
vacuum cleaner. This applies, in particular,
to hardwoods, MDF sheets and ceramics.
Setting the cutting depth (Figure 6)
1.
Loosen the adjustment screw (2).
2.
Adjust the cutting depth according to the
scale (a) and tighten the adjustment screw
(2).
3.
For wood and plastics, the cutting depth
should be selected to be a little deeper
than the material thickness.
4.
A wood underlay can be used to achieve a
better cutting quality. The wood underlay
will, however, be damaged.
Connection to the power supply
Make absolutely sure, before connecting, that
the data on the nameplate agrees with the
mains power supply data. Always pull out the
power plug before making adjustments to the
electric power tool.
Note
ATTENTION!
•
Before undertaking any work on the elec-
tric power tool, unplug it from the mains!
•
Do not use tool inserts which are defective
or which exhibit tears or fissures.
7062244_MaxxSaw_Ma_#1503-19.indb 33
All manuals and user guides at all-guides.com
•
•
OPERATION
General instructions
•
•
•
•
•
•
•
•
•
Switching on and off (Figure1)
Switching on:
Push the safety switch (1b) forward with one
finger and then press the On/Off switch (1a)
keeping it pressed.
Switching off:
Let go of the On/Off switch (1a).
Using the laser (Figure 7)
Using the laser beam-guide makes sawing in a
straight line much easier.
a.
b.
Do not use a flange or flange nut with a
hole larger or smaller than the hole in the
tool insert.
Only use tool inserts of the same type as
those delivered with the electric power
tool. Seek advice from a specialist trader.
Select a suitable tool insert for the material
that is to be worked on.
Check the condition and sharpness of the
tool insert.
Always hold the electric power tool with a
firm grip.
Exert no force! Push the electric power
tool forwards, gently and evenly.
The electric power tool must not be
braked with the hand or by applying lateral
pressure.
The safety guard may not be blocked and
must be returned to the starting position
after the final working step.
Before use of the electric power tool,
inspect the function of the safety guard
with the tool unplugged from the mains.
Before each use of the electric power tool,
make sure that the safety mechanisms
such as the safety guard, flanges and
adjustment devices are functioning and/or
are correctly installed and fastened.
A suitable dust extraction system is to be
connected to the dust extraction connec-
tion (10). Make sure that the dust extrac-
tion is correctly and securely attached.
Either along a drawn line
Or by aligning the beam to a marked
point
.
English
33
09-04-15 11:31
Publicité
Table des Matières
