Important - SOUNDMASTER NR540 Manuel

Phono
operation
1.
Remove the stylus protector.
-
Be sure that the tone arm is being detached from the tone
-
arm rest before operating and re-secured again afterwards.
Select to "Phono" function by pressing Phono/Aux button (24)
1.
2. Set the speed selector (29) to the proper position depending on the record to be played.
3. Place the record on the platter (use the spindle adaptor (26) if required).
4. Set the Tone arm lever (28) to the up position.
5. Lift the tone arm from the rest and slowly move it to the record side. The platter will start to rotate and position the tone arm over
the desired position of the record.
6. Pull down the Tone arm lever (28). The tone arm will come slowly on the recorder and start playback.
7. At the end of record, the tone arm will return to the rest position automatically.
8. To stop manually, lift the tone arm from the record and return it to the rest.
 Play suspension
Set the cueing lever (28) to the up position will life up the tone arm and then stop playback temporarily
Remark:
- Due to the auto return system was mechanical design and reset point will be affected after transportation.
Thus, the tone arm will return to the rest automatically when first time place it to the platter and it was not
the malfunction
- Due to the length of the record is various, if you find the tone arm cannot return automatically after
playback of record. Please return the tone arm back to the rest position manually or adjust the auto return
point as below procedure.

Important:

To make sure the turntable can play the record with different standard completely, a hole with "NO OPEN" PVC plate located at the
back of the unit (33) to adjust the screw inside the turntable.
When the turntable stop early and the auto-return, pls use a screw driver to turn the screw inside the hole about 45 degree in
clockwise direction, if the record still can not be played completely, stop play and re-turn the screw 45 degree in clockwise direction
again, till the turntable can be play the record completely and auto return.
When the turntable can not be stop and auto return but keep running after playing the record completely, pls use a screw driver to
turn the screw inside the hole about 45 degree in counter-clockwise direction, if the record still can not be played completely, stop
play and re-turn the screw 45 degree in counter-clockwise direction again, till the turntable can be play the record completely and
auto return.
Remark: Due to Phono and Aux design in same channel of this unit, once the Aux in jack (2) plugged by any 3.5mm stereo plug, the
Phono function will change to Aux in automatically and the turntable will stop to spin. Made sure the Aux In jack (2) is not plugged by
anything before playing phono.
6
M_NR540 / English Instruction Manual
Stylus assembly
Cartridge