Angelcare AC 201 Manuel De L'utilisateur page 4

• Always place both the Nursery Unit and Parents'
Unit on a flat surface in an upright position and
allow for proper ventilation.
• Avoid damage to the Sensor Pad cord and to the
adapter cords. Route cords so that they are not
likely to be walked on or pinched by items placed
on or against them.
• Route sensor pad cord only below crib matress
and out of reach of children.
• Use ONLY AAA (LR03) batteries (not included)
and/or the AC adapters provided for the Parents'
Units.
• During long periods of non-use remove all bat-
teries from their compartments and unplug the AC
adapters.
• This monitor uses public airwaves to transmit
signals. The Parents' Unit may pick up signals or
interference from other nursery monitors in your
area. Your monitor may even be picked up by
other households. To protect your privacy, make
sure both units are turned off when not in use. If
you experience interference, change the chan-
nel on both units.
• This monitor is perfectly safe. The Sensor Pad
and its cord are entirely passive. They carry no
electrical current and do not radiate any form of
energy. The Nursery Unit emits only very low
power radio signals through its antenna. These
signals do not present a safety hazard.
• When the monitor is in use, do not use a crib
mobile or other crib accessories that may produce
vibrations. Other sources of vibrations may
include fans, washing machines, loud music, etc.
These sources of vibration may interfere with the
performance of your Angelcare® monitor and the
alarm will not sound if it continues to detect any
movement other than your baby's. Be sure all
vibration sources are eliminated before using the
monitor.
• You may experience false alarms for several
reasons. The most common reason is the Nursery
Unit has not been turned off after you have
removed your baby from the crib. Another reason
is the Sensor Pad has not been placed under the
mattress properly. Be sure the Sensor Pad is on a
flat, firm surface with the turquoise side facing up.
The sensitivity level may also need to be adjusted.
Refer to the Movement Sensitivity Adjustment
section on Pg. 12.
• Always be sure to immediately check on baby
whenever an alarm sounds.
• Your monitor can be used in any crib that is sta-
tionary and designed to safely hold a baby. If your
crib has a spring or slat base you will need to
place a piece of Masonite board under the Sensor
Pad. This support must be at least 13 inches long
on all four sides and 1/4 inch thick. Only use your
Angelcare® monitor in a stationary sleeping envi-
ronment such as a crib where the Sensor Pad can
rest on a completely flat, firm surface.
• CLEANING. Disconnect all units before cleaning.
DO NOT immerse in water. Use a dry cloth to keep
monitor free from dust. DO NOT spray with clean-
ing products or solvents. Wipe sensor pad with a
cloth moistened very slightly with an antiseptic or
mild detergent.
4