Care And Maintenance - Angelcare AC 201 Manuel De L'utilisateur

Care and Maintenance

Disconnect all units and remove all batteries before cleaning. Clean the exterior surface of the units
with a soft dry or slightly damp cloth. Do not spray with cleaning products or solvents.
Do not submerge in water or any other liquid.
During long periods of non-use, remove all batteries from their compartments and unplug the AC
adapters.
Troubleshooting
Problem
False alarms
Possible Cause
Baby was removed from crib and the
Nursery Unit was not switched off.
The blue side of the Sensor Pad is not
facing up.
The Sensor Pad is not detecting your
baby's movements because the sensitivi-
ty level is too low.
Sensor Pad is not in full contact with the
crib mattress or is not resting on a flat,
firm surface.
Baby has moved far away from the
Sensor Pad.
15
Solution
Turn the Nursery Unit off.
Make sure the turquoise side is facing
up.
The sensitivity level may need to be
increased.
Refer to the Movement Sensitivity
Adjustment section on Pg. 12.
Make sure there is no thick
bedding between the mattress and the
Sensor Pad. The Sensor Pad must rest
on a firm surface. If the crib has a
spring or slat base, place a piece of
Masonite board measuring at least 13"
on all four sides and ?" thick.
Make sure there is no thick bedding
between the mattress and the Sensor
Pad. The Sensor Pad must rest on a
firm surface. If the crib has a spring or
slat base, place a piece of Masonite
board measuring at least 13" (33cm) on
all four sides and 1/4" (0.64cm) thick.
Refer to the Movement Sensitivity
Adjustment section on Pg. 12.