Angelcare AC 201 Manuel De L'utilisateur page 11

Sound & Movement
Note: Make Sure your Sensor Pad is set up before proceeding with this section. If you haven't set up
your Sensor Pad please go to Pg.9 for instructions on how to properly set up the Sensor Pad.
Switch the Nursery Unit to the "Sound & Movement" function. Turn the Parents' Unit ON by selecting
either channel "A" or "B". Make sure it is set to the same channel as the Nursery Unit. The Movement
Indicator Light on the Nursery Unit will flash red, green, and then emit a single "Tic" sound. Gently pat
your hand on the mattress. The green Movement Indicator Light will continue to flash with every move-
ment. The Nursery Unit will also tick with every movement.
Remove your hand from the mattress. Due to no movement, the ticking will stop, the Movement
Indicator Light will stop flashing, and a pre-alarm beep will sound after 15 seconds. Five seconds later
the alarm will sound and the red Alarm Indicator Light will flash continuously.
Tic Off
You can also test for movement with the Nursery Unit set to the "Tic Off" position. In this case, you will
not hear a constant ticking when you touch the mattress. When you remove your hand from the mat-
tress the Movement Indicator Light will stop flashing, a pre-alarm beep will sound after 15 seconds,
and five seconds later the alarm will sound and the red Alarm Indicator Light will flash continuously.
To turn off the alarm, turn the Nursery Unit off or pat your hand lightly on the mattress so the Sensor
Pad will redetect movement. The red Alarm Indicator Light on the Nursery Unit will continue to flash
for one minute and it will then revert to green.
If the alarm does not sound when you are not touching the mattress, the Sensor Pad may be detect-
ing a continuous vibration from another source from inside and/or outside your baby's room. Common
sources of this interference are crib mobiles, fans, washing machines, or even loud music. Therefore,
it is very important to make sure all vibration sources are eliminated before using the monitor. Place
the crib near a solid supporting wall and away from strong air currents. Do not use crib mobiles or
accessories that may cause vibrations. Avoid contact with the crib when the monitor is in use. If you
find the alarm will still not sound when you are not touching the mattress or crib, the monitor is on,
and you have removed all external sources of vibration, the sensitivity level may need to be decreased.
Please refer to the Movement Sensitivity Adjustment section on page 12.
• Sound & Movement: You will be able to hear your
baby's sounds, see sound lights, and hear a "Tic" sound
with every movement your baby makes. If no movement
is detected, the"Tic" will stop and after 20 seconds the
alarm will sound.
11