Angelcare AC 201 Manuel De L'utilisateur page 17

Problem
Power Indicator (green light) does
not light up.
There is very weak reception.
There is static, distortion,
interference, etc.
There is feedback
(squealing noises).
IMPORTANT! This Angelcare® monitor is a personal care product.
Possible Cause
Batteries are low or improperly
installed.
AC adapters are not connected
properly or electrical outlet is
out of order.
One of the units is not on.
Parents' and Nursery Units are
too far apart.
One or both units are placed
near a large metal mass.
One or both units are not in the upright
position.
Batteries are low.
Parents' and Nursery Units are
too far apart.
Units are not set to the same channel.
One of the units is not on.
The Parents' Unit is located near motor-
ized devices,
fluorescent lights, television, etc.
Units are too close to each other.
The volume is too high.
Please do not return this product to the store.
If you have questions or need help, please
call Angelcare before returning this product.
Replacement Parts
Warranty Information (USA & Canada only)
www.angelcare-monitor.com
angelcare@cdecinc.ca
1 877 281 8827
17
Solution
Check or replace batteries.
Check connections or change to anoth-
er electrical outlet.
Make sure both units are on the same
channel, either both on A or B.
Bring Parents' Unit closer to
Nursery Unit.
Change the position of one or
both units.
Place units on flat surface away from
baby's reach.
Check or replace batteries.
Bring Parents' Unit closer to
Nursery Unit.
Make sure both units are on the same
channel, either both on A or B.
Make sure both units are on.
Rotate Parents' Unit or move
it away from source of
interference.
Move units farther apart
(at least 10 feet apart).
Decrease volume on Parents'
Unit.