MINN KOTA TERROVA Instructions D'installation page 9

7
ITEM(S) NEEDED
#1 x 6
k. Put a 1/4-20 x 3 1/2" (Item #1) screw in each
of the drilled locations. The screw should pass
through the Base Extrusion and the boat deck.
If the rubber washers (Item #4) are used, they
should sit between the Base Extrusion and boat
deck. Make sure to secure the motor with screws
on each side of the Base Extrusion.
l. Place a Flat Washer (Item #2) and then a Nylock
Nut (Item #3) at the end of each screw as shown
and secure. Make sure all hardware is secure.
NOTE:
To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Wetting the screws or applying an anti-seize may
help prevent seizing.
8
m. Replace the Right Sideplate.
n. Swing the Left Sideplate back into its correct
position on the Base Extrusion.
8m
©2016 Johnson Outdoors Marine Electronics, Inc.
#2 x 6 #3 x 6
Right Sideplate
INSTALLING THE TERROVA
#4 x 6
Screw
Boat Deck
Rubber Washer
Nylock Nut
Flat Washer
8n
Base Extrusion
Left Sideplate
minnkotamotors.com | 9