MINN KOTA TERROVA Instructions D'installation page 6

INSTALLING THE TERROVA
MOUNTING CONSIDERATIONS
It is recommended that the motor be mounted as close to the centerline of the boat
as possible. Make sure the area under the mounting location is clear to drill holes and
install nuts and washers. Make sure the motor rest is positioned far enough beyond the
edge of the boat. The motor must not encounter any obstructions as it is lowered into
the water or raised into the boat when stowed and deployed. Consider a quick release
or adapter bracket with the installation of your motor. To view a list of accessories,
please visit minnkotamotors.com.
TOOLS AND RESOURCES REQUIRED
• #3 Phillips Screw Driver
• Drill
• 9/32" Drill Bit
INSTALLATION
Installing the Terrova
1
a. Place the mount on an elevated, level surface
such as a workbench or the tailgate of a pickup.
The motor, as removed from the box, should be in
the stowed position.
b. Remove the four sideplate screws using a #3
Phillips screwdriver. Two of these screws will be
located on each side of the mount.
NOTE:
This motor weighs approximately
65lbs. We recommend having a second person
help with the installation.
6 | minnkotamotors.com
• 7/16" Box End Wrench
• A second person to help with the
installation
1b
Sideplate Screw
Deployed
©2016 Johnson Outdoors Marine Electronics, Inc.
View accessories
available for your
trolling motor at
minnkotamotors.
com.
Stowed