MINN KOTA TERROVA Instructions D'installation page 8

INSTALLING THE TERROVA
5
ITEM(S) NEEDED
#4 x 6
g. When the motor is in the delpoyed position, make
sure that the Shaft is 1-1/2" out past the Gunwale
of the boat. The lower unit, when stowed and
deployed must not encounter any obstructions.
h. Check to be sure that the mount is level. Use the
Rubber Washers (Item #4) provided to create a
level surface if necessary.
6
i. It is recommended to mark at least 4 of the
6 holes in the Base Extrusion and to have a
minimum of two bolts on each side that are
located the farthest apart. Ideal installation would
allow for 6 bolts to be used, with a minimum of 4.
j. Drill through the deck of the boat using a 9/32"
Drill Bit on the marked locations.
8 | minnkotamotors.com
Gunwale
1-1/2"
Minimum
Drilling Locations
Drilling Locations
©2016 Johnson Outdoors Marine Electronics, Inc.
Shaft
Base Extrusion