MINN KOTA TERROVA Instructions D'installation page 12

ROUTING UNIVERSAL SONAR & -PILOT LINK CABLES
1
a. Place the motor in the deployed position.
b. Locate the Universal Sonar and/or the i-Pilot Link
cable(s), at the base of the Control Head.
CAUTION
Not following the recommended wire routing for the
Universal Sonar and/or i-Pilot Link cable(s), if equipped,
may cause damage to the product and void your product
warranty. Route cables away from pinch points or other
areas that may cause them to bend in sharp angles.
Routing the cables in any way other than directed may
cause damage to the cables by being pinched or severed.
c. The Universal Sonar Cable and/or i-Pilot Link
cable should be fed all the way through the Coil
Cord. It/they should exit the Coil Cord at the
bottom of the Coil Cod, where it connects to the
Mount.
12 | minnkotamotors.com
i
Control Head
i-Pilot Link
Universal
Sonar
Coil Cord
Mount
NOTE: After the Universal Sonar Cable and/or i-Pilot
Link Cable exits the Coil Cord, it should be routed
through an established routing system on the boat, in
an area with minimal interference. Inspect the selected
route carefully to ensure that there are no sharp
edges, obstacles, or obstructions that may damage
the cables.
©2016 Johnson Outdoors Marine Electronics, Inc.