Disposal Of The Old Device - CASO DESIGN GourmetVAC 480 Mode D'emploi Original

The bag is not being
sealed correctly
The bag does not hold
the vacuum after it has
been sealed
► In the event of technical troubles, faulty devices or missing parts, please contact
Customer Service.

19 Disposal of the Old Device

To protect the environment, it's important to dispose of old electronic devices
properly. Do not place your old unit in the non-recyclable waste under any
circumstances.
Please take your old unit to the nearest recycling center for safe disposal.
►
Until it can be disposed of properly, store your old unit away from children.
►
20 Guarantee
We provide a 24 month guarantee for this product, commencing from the date of sale, for
faults which are attributable to production or material faults.
Your legal guarantee entitlements in accordance with § 439 ff. BGB-E remain unaffected
by this. The guarantee does not include damages, which were incurred as a result of
improper handling or use, as well as malfunctions which only have a minor effect on the
function or the value of the device. Consumables, transit damages, inasmuch as we are
not responsible for these, as well as damages, which were incurred as a result of any
repairs that were not performed by us, are also excluded from the guarantee entitlements.
This device is designed for use in domestic situations and has the appropriate
performance levels. Any use in commercial situations is only covered under the guarantee
to the extent that it would be comparable with the stresses of being used in a domestic
situation. It is not intended for any additional, commercial use.
In the event of justified complaints, we will repair the faulty device at our discretion or
replace it with a trouble-free device.
Any pending faults must be reported within 14 days of delivery.
The sealing bar is
overheating so that the bag
melts
Roll / bag is not positioned
correctly.
The bag is defective
There are leaks along the
welding seam as a result of
creases, crumbs, grease or
liquids.
PLEASE NOTE
PLEASE NOTE
Open the cover on the unit and
let it cool down for a few minutes.
Please use only specified bags
and rolls
Carefully follow all the steps in
Chapter Vacuuming and sealing.
Select another bag; wrap paper
around any sharp edges within
the bag.
Open the bag again and clean
the upper internal part of the bag.
Remove any foreign matter that
might be on the welding bar
before sealing.
48