Disposal Of The Old Device; Guarantee - CASO DESIGN VC 250 Mode D'emploi

Error
A complete vacuum is
not being created in
the bag.
The bag is not being
welded correctly
The bag does not hold
the vacuum after it has
been welded shut
Please note
► If you are unable to solve the problem with the steps shown above, please contact
Customer Service.

8 Disposal of the Old Device

Old electric and electronic devices frequently still contain valuable materials.
However, they also contain damaging substances, which were necessary for their
functionality and safety. If these were put in the non-recyclable waste or were
handled incorrectly, they could be detrimental to human health and the
environment. Therefore, do not put your old device into the non-recyclable waste
under any circumstances.
Please note
► Utilize the collection point, established in your town, to return and recycle old electric and
electronic devices. If necessary, contact your town hall, local refuse collection service or
your dealer for information.
► Ensure that your old device is stored safely away from children until it is taken away.

9 Guarantee

Caso USA WARRANTY
We provide a 12 month guarantee for this product, commencing from the date of sale, for
faults which are attributable to production or material faults.
Possible Cause
The bag is defective
There is dirt on the welding
and the normal seals
The welding bar is
overheating so that the bag
melts
The bag is defective
There are leaks along the
welding seam as a result of
creases, crumbs, grease or
liquids.
Solution
Select another bag
Clean the seals and retry correctly
once they are dry
Open the cover on the unit and let
it cool down for a few minutes
Select another bag; wrap paper
serviettes around any sharp edges
on the content
Open the bag again and clean the
upper internal part of the bag and
remove any foreign matter that
might be on the welding bar before
you weld the bag shut again.
16