Starting The Engine; Working Notes - Grizzly MTR 25 Traduction De La Notice D'utilisation Originale

All manuals and user guides at all-guides.com

Starting the Engine

Start the engine at least three me-
tres from the filling location
Place the appliance on a solid and
even surface. Check that the blade
is not touching any objects or the
ground.
1. Remove the protective cap on the
thread cutter (see
2 To start the ignition, move the On/
Off switch (11) at the multifunc-
tion handle to
3. For a cold start, set the choke
lever (5) to the "cold start" posi-
tion.
For a warm start, leave the
choke lever (5) in the "warm
start". position.
4. Press the fuel pump 6x (3).
5. Hold the equipment firmly with
one hand on the top shaft tube
(14). With the other hand, pull
the starter cable several times
on the starter handle (7) until
the engine starts.
Caution! Do not pull the
starter cable out too far – risk
of breaking!
6. Allow a cold motor to warm up
for approx. 10 seconds then set
the choke lever (5) to the "warm
start" position.
7. If the equipment does not start,
repeat stages 3 to 5.
8. Attach the equipment to the car-
rying strap that has been put on
(see chapter on "Putting on the
Carrying Strap").
9. To mow, hold the throttle lock
(9) depressed and operate the
throttle (10).
Operation
17).

Working Notes

.
•
•
•
•
•
•
•
•
•
•
•
•
•
10. To switch off the engine, set the
on/off switch (11) to the „STOP"
position.
If the engine fails to start after a
second attempt, try to start it in the
"warm start" position without the
choke. If this is unsuccessful, fol-
low the instructions in the chapter
on "Troubleshooting".
When cutting, observe the country-
specific / local regulations.
Do not cut during commonly applica-
ble quiet periods.
Solid objects such as stones, metal
pieces or similar must be removed.
These can be thrown out and there-
fore result in personal or property
damage.
When cutting in high bushes or hedg-
es, the working height should be at
least 15 cm. This prevents the risk to
animals, e.g. hedgehogs.
Always hold the equipment firmly and
securely with both hands
(see picture 8).
Cut only grass and weeds. Be aware
of roots or tree stumps – risk of trip-
ping.
Work considerately and endanger no-
body when cutting. Work quietly and
carefully.
Work only in adequate visibility and
lighting conditions.
Keep an eye on the cutting head.
Never cut above shoulder height.
Never replace the plastic cord with a
steel wire – risk of injury and damage.
Do not work on a ladder.
Work only on firm and stable bases.
GB
79