Safety instructions
Pos: 1
5
Safety instructions
It is important to follow these safety instructions to prevent personal
injury and property damage. These instructions apply in addition to
standard safety practices for working places.
•
It is essential that you read the user information before starting the
unit.
•
Use PPE (safety gloves, safety shoes, safety goggles).
•
Transport the unit carefully. The interior of the unit can also be
damaged by impacts or if it is dropped.
•
Do not stay under the unit when transporting and operating.
•
Operation is permitted with non-flammable liquids only.
•
Only operate the unit in rooms that are well-ventilated, dry and free
of frost.
•
Place the unit on a flat surface of non-flammable material.
•
Do not start the unit if it is damaged or leaking.
•
Compare the mains voltage and frequency with the specifications on
the type plate.
•
Only connect the unit to a fused mains connection via a FI circuit
breaker (Ia=30 mA).
•
The power supply plug serves as safe disconnecting device from the
power supply network and must be freely accessible at all times.
•
Check the mains cable regularly for signs of damage.
•
Never operate equipment with damaged mains power cables.
•
Condensation that could appear in and on other units near the water
bath may result in reduced operating safety.
Be careful when setting up and operating the water bath!
•
Some parts of the bath cover may become extremely warm during
continuous operation. When lifting the bath cover, pay attention to
hot steam!
•
Never use the unit without bath fluid.
•
Do not reach into the thermal bath fluid.
•
Do not drain the bath fluid while it is hot!
•
Check the temperature of the bath fluid prior to draining (by
switching the unit on for a short moment for example).
•
Always turn off the unit and disconnect the mains cable from the
power source before performing any service or maintenance
procedures, or before moving the unit.
•
Have all service and repair work carried out by authorized specialists
only.
33