Manufacturer's Warranty; Ec Declaration Of Conformity; Spare Parts Lists - Roller King 1 1/4 Notice D'utilisation

eng
Fault
Die head does not cut
Automatik die head does not open
after cutting operation
Torn thread
Pipe turns in support
bracket during cutting operation
Die head jams during changing
6. Disposal
The units may not be thrown into the domestic waste at the end of use. They
must be disposed of properly by law.
7. Manufacturer's Warranty
The warranty period shall be 12 months from delivery of the new product to the
first user. The date of delivery shall be documented by the submission of the
original purchase documents, which must include the date of purchase and the
designation of the product. All functional defects occurring within the warranty
period, which are clearly the consequence of defects in production or materials,
will be remedied free of charge. The remedy of defects shall not extend or
renew the warranty period for the product. Damage attributable to natural wear
and tear, incorrect treatment or misuse, failure to observe the operational
instructions, unsuitable operating materials, excessive demand, use for unau-
thorized purposes, interventions by the customer or a third party or other
reasons, for which ROLLER is not responsible, shall be excluded from the
warranty.
Services under the warranty may only be provided by customer service stations
authorized for this purpose by ROLLER. Complaints will only be accepted if
the product is returned to a customer service station authorized by ROLLER
without prior interference in an unassembled condition. Replaced products and
parts shall become the property of ROLLER.
The user shall be responsible for the cost of shipping and returning the product.
The legal rights of the user, in particular the right to make claims against the
seller under the warranty terms, shall not be affected. This manufacturer's
warranty only applies for new products which are purchased in the European
Union, in Norway or in Switzerland.
This warranty is subject to German law with the exclusion of the United Nations
Convention on Contracts for the International Sales of Goods (CISG).
8. EC declaration of conformity
ROLLER declares that the products decribed in this user manual comply with
corresponding directives 2004/108/EC/EMC, 2006/95/EC/LVD, 2006/42/EC(MD).
Correspondingly this applies to the following norms: 60745-1(ed.4) EN
50366:03+A1:06, EN 55014-1:06+A1:09, EN 55014-2:97+A1:01+A2:08, EN
60745-1:09, EN 60745-2-9:09, EN 60745-2-9:09, EN 61000-3-2:06+A1:09+A2:09,
EN 61000-3-3:08, EN 6223:08.
Waiblingen, 01. 02. 2011
Albert ROLLER GmbH & Co KG
Manufacturer of Tools and Machines
D-71332 Waiblingen
Rainer Hech
9. Spare parts lists
For spare parts lists, see www.albert-roller.de → Downloads → Parts lists.
All manuals and user guides at all-guides.com
Possible cause
Blunt or broken dies
Rotation objection false
Dirty die guide slots
Dies blunt
Dies not fitted in correct order
Poor quality material
Unsuitable thread cutting oil
Fine scale and dirt on the gripping
jaws
Swarf on the arresting part of die head
Remedy
Fit new dies
Check position or change-over switch
Open die head, remove dies, wash guide slots
and dies with cold cleaner or paraffin.
Grease before reassembly.
Fit new set of dies
Fit dies in correct order
Observe mark of quality when buying material
Use ROLLER thread cutting oil
Clean with wire brush
Remove sworf with flat file
eng