Installation; Water Supply - Conti CC100 Notice Technique

19.

INSTALLATION

19.1. IN CASE OF A STANDBY OF THE MACHINE (STANDBY = 2 MONTHS):

The first thing to do is to test your machine in a lab.

If the machine stop ruming for a long time, you could have scale in some places.

More precisely in small area like the spray nozzle.
19.2. PROTECTIONS

It is necessary to place before the machine:
o A water shutoff valve.

19.3. WATER SUPPLY


Recommended operating pressure from 0.2 MPa to 0.6 MPa

Water connection pin 3/8"

The water supply pipes must resist to 145 Psi / 1 MPa
19.4. DRAIN

Without pressure.

Spigot at the outlet of the machine and a pipe is supplied with the machine

Ensure a connection that causes no risk of fluid return, and ensure good drainage:


19.5. SUPPLYING VOLTAGE
According to the model:
 220-230V – 50/60Hz Singlephase
 380-400V – 50/60Hz Threephase
SACOME, CONFIDENTIAL Document,
The drain pipe must be located lower than the machine.
Do not create a bend in the exhaust tube.
Edition 07/2018 - CC100
TECHNICAL DOCUMENTS - page 31
it is forbidden to duplicate or communicate this document without previous authorization.