Conti CC100 Notice Technique page 36


MANOMETER M1 : BOILER PRESSURE
The boiler pressure is adjusted in factory between 0,8 MPa (12 PSI) and 1 MPa (15 PSI). This value
varies slightly around its nominal temperature, due to the PID system which controls the heating and
limit the current consumption to its minimum.
NOTE: An over-heating thermostat will cut the heating, in case of an abnormal high temperature.

MANOMETER M2 : PUMP PRESSURE
The pump pressure is adjusted at 0.9 MPa in the factory. Value which allows the best extraction of
coffee flavors. A bypass system evacuates over-pressure.
NOTE: Simultaneous operation of all the groups can impact a little bit the pressure level.
Visualization of the presence of water network is done by consulting the gauge
21.2.
 Simply select one of the buttons available on each keypad to obtain the doses or the
programmed drinks.
 The selected dose is shown by a blinking led on the keypad.
 The flow can be stopped by repressing:
o The same button or
o The STOP button (which is also the programming and continuous flow button).
SACOME, CONFIDENTIAL Document,
HOW TO USE THE PROGRAMMED DOSES
Edition 07/2018 - CC100
TECHNICAL DOCUMENTS - page 35
it is forbidden to duplicate or communicate this document without previous authorization.