Install The Refrigerator - Norcold Polar 10 Serie Manuel D'installation

Install the Refrigerator

1. Put the refrigerator in position (See Art 02646, Art 01688, and Art 01689):
Make sure the combustion seal [28] is not broken, is
!
WARNING
completely around the refrigerator mounting flanges, and is
between the mounting flanges and the wall of the enclosure If
the seal is not complete, exhaust fumes can be present in the
living area of the vehicle. The breathing of exhaust fumes can
cause dizziness, nausea, or in extreme cases, death.
Be careful when you put the refrigerator into position. The refrigerator
NOTICE
has vacuum insulating panels. If punctured, these panels lose
insulation value which decreases the cooling performance of the
refrigerator.
- Push the refrigerator completely into the enclosure.
- Put two mounting screws [41] through the lower mounting flange [211] on the front
of the refrigerator and into the enclosure wall.
- Put two mounting screws [41] through the upper mounting flange [210] on the front
of the refrigerator and into the enclosure wall.
2. Install the upper and lower trim pieces:
These trim pieces are not the same. Make sure that the notch [208] in
NOTICE
the upper and lower trim pieces fit around the upper and lower cabinet
hinge.
- Align the tabs of each trim piece with the rectangular holes of each mounting flange.
- Push the lower trim piece [128] onto the front of the lower mounting flange [211]
until you feel both ends engage and hear a "snap" sound.
- Push the upper trim piece [40] onto the front of the upper mounting flange [210] until you feel both ends engage and hear a "snap"
sound.
- Put screws through mounting flange on the rear of the refrigerator and into the floor.
210
40
Installation Manual 12
211
41
Art 01689
28
Art 02646
208
128
41
Art 01688