Install The Refrigerator - Norcold NX64 Manuel D'installation

Install the Refrigerator

Put the refrigerator in position (See Art00962, Art00963, and Art00964):
Make sure the combustion seal [28] is not broken, is completely
!
WARNING
around the refrigerator mounting flanges, and is between the
mounting flanges and the wall of the enclosure If the seal is not
complete, exhaust fumes can be present in the living area of the
vehicle. The breathing of exhaust fumes can cause dizziness,
nausea, or in extreme cases, death.
- Push the refrigerator completely into the enclosure.
- Put the upper trim piece [40] onto the front of the refrigerator.
- Put screws [41] through the upper and lower mounting flanges on the front of the
refrigerator and into the enclosure wall and floor.
- Put a cap [42] on each of the screw holes in the upper trim piece [40] on the front of the
refrigerator.
Do not omit the bottom trim piece. This piece is part of the
!
WARNING
combustion seal.
- Push the bottom trim piece [29] onto the front of the refrigerator.
- Put two screws [41] through the trim piece, the mounting flange, and into the floor.
- Put screws through mounting flange on the rear of the refrigerator and into the
floor.
40
41
42
41
Art00964
Installation Manual 11
28
29
Art00962
Art00963
41
29