Examine The Gas Supply System For Leaks; Install The Refrigerator - Norcold N180 3 Serie Manuel D'installation

- Put the propane gas supply line up through the floor of the enclosure.
- Make sure the hole through the floor is large enough to allow clearance for the gas supply line.
- Put a weather resistant seal (grommet, sealant, etc.) around the gas supply line where it goes through the floor to prevent vibration
and abrasion.
- To prevent vibration and abrasion, make sure that the gas supply line is not against anything in the enclosure.
- Attach the gas supply line to the 3/8 inch male flare fitting [312] of the refrigerator (See Art02583).

Examine the gas supply system for leaks:

Do not allow the leak detecting solution to touch the electrical components. Many liquids are electrically
!
WARNING
conductive and can cause a shock hazard, electrical shorts, and in some cases, fire.
Use a leak detecting solution to examine the gas supply line and all propane gas connections for leaks.
If you use compressed air for the test:
- The pressure at the 3/8 inch male flare fitting of the refrigerator must not be more than 1/2 psig (14 inches Water Column).
- If the air pressure is more than 1/2 psig (14 inches Water Column), remove the gas supply line from the 3/8 inch male flare fitting of
the refrigerator before the test.
- If the air pressure is equal to or less than 1/2 psig (14 inches Water Column), push and turn the gas control to the off position (
before the test.

Install the Refrigerator

Put the refrigerator in position (see Art02584):
Make sure the combustion seal [28] is not broken, is completely around the refrigerator mounting flanges
!
WARNING
[156], and is between the mounting flanges and the wall of the enclosure. If the combustion seal is not
complete, exhaust fumes can be present in the living area of the vehicle. The breathing of exhaust fumes
can cause dizziness, nausea, or in extreme cases, death.
- Put screws through the holes of the refrigerator mounting flanges and into the enclosure wall.
To avoid bending the breaker, make sure that the screws are
NOTICE
perpendicular to the breaker and do not overtighten the screws.
Installation Manual 8
28
156
ART 02584
)