Install The Refrigerator; Connect The Electrical Components; Connect The 120 Volts Ac Supply - Norcold N260.3 Manuel D'installation

Install the Refrigerator

Make sure the seal strips [28] are not broken, are completely
!
WARNING around the refrigerator mounting flanges, and are between the
refrigerator mounting flanges and the wall of the enclosure
(See Art00951). If the seal is not complete, exhaust fumes can
be present in the living area of the vehicle. The breathing of
exhaust fumes can cause dizziness, nausea, or in extreme
cases, death.
1. Put screws through the refrigerator mounting flanges and into the wall of the enclosure.
3. Put screws through the braces at the lower rear corners of the refrigerator and into the
floor.

Connect the Electrical Components

AC Operation
Current Draw:
DC Operation
Current Draw:
This refrigerator operates on these electrical sources. Operation out of these limits may damage the refrigerator's electrical circuit parts
and will void the warranty.
The rear of the refrigerator cooling system has hot surfaces and sharp surfaces that can damage electrical
! wiring. Make sure that there is a good clearance between all electrical wiring and the cooling system of the
WARNING
refrigerator. Position any electrical wiring within the refrigerator enclosure opposite the burner side of the
refrigerator. Do not put any electrical wiring through the roof exhaust vent. Failure to correctly position
electrical wiring can result in electrical shock or fire.

Connect the 120 volts AC supply:

Connect the AC power cord only to a grounded three-prong receptacle. Do not remove the round ground
prong from the power cord. Do not use a two-prong adapter or an extension cord. Operation of the
!
WARNING
refrigerator without a correct ground could cause dangerous electrical shock or death if you are touching
the metal parts of the refrigerator or the vehicle.
Put the AC power cord into a grounded three-prong receptacle:
- Make sure the receptacle is within easy reach of the lower intake vent.
- Make sure the power cord does not touch the burner cover, the flue pipe, or any hot component that could damage the insulation of
the power cord.
Installation Manual 8
120 volts AC voltage
1.3 Amps at 110 volts AC
1.4 Amps at 120 volts AC
12 volts DC voltage
11.7 Amps at 12 volts DC
13.6 Amps at 14 volts DC
( 108 volts min. - 132 volts max.)
(11.5 volts min. - 15.4 volts max.)
28
Art00951