Stihl MS 250 Notice D'emploi page 18

English
Start felling cut using plunge-cut
N
method.
Enlarge felling cut as far as
N
hinge (4).
Do not cut into the hinge.
–
Enlarge felling cut as far as
N
stabilizing strap (5).
Do not cut into the stabilizing strap.
–
Insert a felling wedge (6).
N
Shout a second warning immediately
before the tree falls.
Holding the saw with outstretched
N
arms, cut through the stabilizing
strap horizontally at the same level
as the felling cut.
16
Felling Cut with Holding Strap (Leaner)
A) Small diameter trees
Perform this felling cut when the tree
diameter is smaller than the length of the
guide bar.
6.
Plunge the guide bar into the trunk
N
until it emerges at the other side.
Enlarge the felling cut (E) in
N
direction of hinge (1).
Cut horizontally.
–
Do not cut into the hinge.
–
Enlarge the felling cut in direction of
N
holding strap (2).
Cut horizontally.
–
Do not cut into the holding strap.
–
1. 2.
Shout a second warning immediately
before the tree falls.
N
Cut through the holding strap at a
downward angle from outside with
outstretched arms.
MS 250