Counting - KERN AGB Série Mode D'emploi

Counting

Purpose
With the Counting program you can
determine the number of parts that each
have approximately equal weight.
Preparation
Configure the Counting application
in the operating menu:
See "Configuring the Balance"
Menu code: 2. 1. 4
Example
Determine an unknown piece count; weigh the preset reference sample quantity
Menu: Application program: Counting (menu code 2. 1. 4);
Reference sample quantity: 20 pcs (menu code 3. 3. 3)
Step
1. Tare the balance
2. Display the reference sample
quantity (here: 20 pcs)
3. Place the reference sample
quantity (20 pcs) on the balance
(here: 66 g)
4. Start the application; if the print
format is set to include data
ID codes, the following piece
weight is printed
5. Weigh uncounted parts
(here: 174 pcs)
6. Display weight
7. Display quantity
8. Unload the balance
9. Delete the reference value
10. Repeat the procedure starting from step 5, if desired
42
$ Reference sample quantity:
Code 3. 3. 1
Code 3. 3. 2
Code 3. 3. 3
Code 3. 3. 4
Code 3. 3. 5
$ Storage parameter
(display accuracy for counting)
Code 3. 4. 1
Code 3. 4. 2
See also "Configuring the Balance"
Key (or instruction)
t
v >2 sec.
v
v
v
c
5 pcs
10 pcs (factory setting)
20 pcs
50 pcs
100 pcs
Standard resolution
(factory setting)
With 10 times higher
resolution than standard
Display/Printout
0.0
g
ref 20
(briefly)
+
66.0
g
+
20
pcs
wRef + 3.300 g
+
174
pcs
+
574.2
g
+
174
pcs
0
pcs