PowerWalker VFI 1000RT LCD Manuel page 8

Tower Setup and Rack-Mount Setup.
 Tower setup
This series of UPS can be placed horizontally and vertically. As a tower
EN
configuration, it is provided with the optional UPS stands to stabilize the UPS
when the UPS is positioned in vertical. The UPS stand must be attached to
the bottom of the tower. Use the following procedure to install UPS in UPS
stands.
1. Slide down the UPS vertically and put two UPS stands at the end of the
tower.
2. Place down the UPS into two stands carefully.
3. Pull out the LCD box and rotate it in a clockwise direction to 90 degree and
then push it back in the front panel.
 Rack-mount setup
The series can be installed in 19 inches racks. Both the UPS and external
battery enclosure need 2U of rack space.
Use the following procedure to install UPS in a rack.
1. Align the mounting ears with screw holes on the side of the UPS, and
tighten the screw.
2. Assemble the rack rails with the rack-mounting.
3. Slide in the UPS into the rack rail and lock it in the Rack-mounting.
4. Tighten the screw, and then the load can be connected.
4