PowerWalker VFI 1000RT LCD Manuel page 7

least 25cm of space on each side.

In case smoke is found coming out from the device, please cut off the
power supply quickly and contact the distributor.

An appropriate disconnect device as short-circuit backup protection
should be provided in the building wiring installation. Please see the
disconnect device specification in chapter 5.2

Do not keep or use this product in any of the following environments:
- Any area with combustible gas, corrosive substance, heavy dust,
standing water or running water.
- Any area with extraordinarily high or low temperature (above 40˚C
or below 0˚C) and humidity of more than 90%.
- Any area exposed to direct sunshine or near any heating
apparatus. (Maximum ambient temperature rating is 40°C.)
- Any area with serious vibrations.
- Outdoor.

In the event that there is fire occurring in the vicinity, please use
dry-power extinguishers. The use of liquid extinguishers may give rise
to the danger of electric shock.
1.1.1 Inspection of Unit
Inspect the UPS upon receiving. If the UPS is apparently damaged during the
shipment, please keep the box and packing material in original form for the
carrier and notify the carrier and dealer immediately.
1.1.2 Unpacking the Cabinet
To unpack the system:
1. Open the outer carton and remove the accessories packaged with the
cabinet.
2. Carefully lift the cabinet out of the outer carton and set it on a flat, stable
surface.
3. Discard or recycle the packaging in a responsible manner, or store it for
future use.
1.1.3 UPS Setup
All model series are designed for tower and rack purpose. They can be
installed into a 19 inches equipment rack. Please follow the instruction for
EN
3