PowerWalker VFI 1000RT LCD Manuel page 30

EN
■ The Bypass mode
The UPS does not have the backup function when it is in bypass mode. The
power used by the load is supplied from the utility power via internal filter.
6.4 NO output mode
The LCD display in No output mode is shown in the following diagram. The
information about the utility power, the battery level, the UPS output and the
load level could be displayed. The "STbY" string indicates the UPS is working
in the No output mode.
■ The No output mode
6.5 EPO (Emergency Power Off)
It is also called RPO (Remote Power Off). On LCD display, the mode string is
"EPO".
It is a special status in which the UPS would shut the output off and alarm.
The UPS could not be turned off by pressing "OFF" button on the panel, only
after releasing EPO status by turning off the EPO switch.
6.6 ECO mode (Economy mode)
It is also called high efficiency mode. In ECO mode, on LCD display, the mode
sting is "ECO".
After the UPS is turned on, the power used by the load is supplied from the
26