PowerWalker VFI 1000RT LCD Manuel page 24

(2) UPS Output Connection
The output of the UPS is IEC socket-types. Simply plug the load power cord
to the output sockets to complete connection. Use one cord for every 5A
load.
EN
The wiring configuration is shown as the
following procedure:
a) Remove the small cover of the terminal block
b) Use 2.5mm
c) Upon completion of the wiring configuration,
please check whether the wires are securely
affixed
d) Put the small cover back to the rear panel
Caution:
Do not connect equipment which would overload the UPS system (e.g.
laser printers)
(3) EPO Connection:
User can select the polarity of EPO, EPO is Normally open as default
setting.
 NO
Normally the EPO connector is open on the rear panel. Once the connector is
closed with a wire, the UPS would stop the output until the EPO status is
disabled.
20
Model No.
1K(S)/1.5K(S)/ 2K(S)
3K(S)
2
wires for wiring configuration
Disable the EPO status
Output Socket (pcs)
8 * IEC320 C13
8 * IEC320 C13 + 1 * C19
Connection diagram
Enable the EPO status