Processing; Accessories/Single Components - Amanngirrbach artex Mode D'emploi

▷ into the transfer stand.
▷ Tighten adapter screw [20].
▷ Raise the table [c] to just beneath the bite fork
and tighten the Allen screw [b]. Remove the
joint and bite fork from the transfer stand.
▷ Mix a small amount of articulating plaster (Arti-
fix 711211) to a creamy consistency and place it
onto the table.
▷ Reinsert the universal joint with the registra-
tion, i.e. place the bite fork above the soft plas-
ter mush, and tighten the adapter screw [20] so
that the bite fork rests on the soft plaster.
Once the plaster has set:
▷ loosen adapter screw [20], toggle nut [23] and
collar screw [22] to separate the joint and bite
fork. [a] = socket for Allen wrench).
▷ Remove the transfer table from the transfer
stand for articulation.
6

Processing

All components with semi-critical contact
to the patient must be cleaned, disin-
fected and sterilised before each use (see
Artex facebow preparation instructions).
This also applies in particular for first use
after delivery, as these components are
delivered non-sterile.
The usual surface disinfection procedures can be
used for all other components (without contact to
the patient).
7 Accessories/single com-
ponents
Art.-No.
217650 Artex Quickbite (20898), 10 pcs.
217611 Bite fork partial two-pack
217611UNI Bite fork partial UNI two-pack
217661 Bite fork total two-pack
217928 Tray handle, 5 pcs.
Porus Buttons "Standard", pair
218607
218609 Porus Buttons long, pair
218610 Axis-plane pointer w. screw
218620 Joint Support
218680 Leipzig nasion
218690 Nasion vertically adjustable
217695 Nasion adapter
Tab. 1
P R O C E S S I N G
E N
17