Angelcare® Monitor Installation - Angelcare AC1100 Manuel De L'utilisateur

ANGELCARE MONITOR INSTALLATION
®
A. INSTALL THE PARENTS UNIT
POWER
On/Off
E
B. INSTALL SENSOR PAD UNDER THE MATTRESS
N
Sensor Pad
I sensor pad
Crib center
A B
Mattress
HardbBoard
(not included)
Crib Base
(Available in certain countries only)
Please refer to SETTING pages for further details
C
2 sensor pads
Crib center
62
1. Remove the belt clip, unscrew the
back panel and insert the 3 AAA
NIMH rechargeable
included into Parents Unit.
2. Connect the AC adapter to the
Parents Unit charger and plug
adapter into the electrical outlet.
Charge for a minimum of 10
continuous hours before using the
monitor for the first time.
3. Turn the Parents Unit ON by pushing
and holding the POWER button for 2
seconds.
4. Screen A will appear and then turn to
the video caption B. When the
Nursery Unit is OFF, screen C will
appear and the Parents Unit will
automatically shut off after 1 minute.
In this case, turn ON the Nursery Unit
and then turn ON the Parents Unit
again.
1. Remove mattress from the crib. Place
a hard board in the center base of the
crib, right under the Sensor Pad(s).
2. Position the Sensor Pad (as shown),
in the center of the crib. Make sure
the printed side faces up. Do not
place any bedding between the
mattress and the Sensor Pad.
batteries