Angelcare AC1100 Manuel De L'utilisateur page 69

2.3 VOX ADJUSTMENT
Vox sensitivity levels.
2.4 ALARM SET-UP
2.5 BATTERY CAPACITY DISPLAY
A)
Low
Full
B)
2.6 KEY TONE SETTINGS
Sound alarm
Sound alarm and vibration
Vibration only
1/3 full 2/3 full
The Vox function is the sound reception on "voice activated
mode". The microphone sensitivity can be adjusted as
follows: A low Vox microphone sensitivity means that the
sound from the baby's room has to be louder to trigger
sound transmission to the Parents Unit.
1. Press the SUB-MENU icon.
2. Press the microphone sensitivity key to the desired
level 1 lowest) to 4 (highest).
3. Press OK to confirm and return to the MAIN MENU.
1. Press the SUB-MENU icon.
2. Press the ALARM icon.
3. You can select one of the three following alarm modes:
Sound alarm, sound alarm and vibration or vibration only.
The symbol representing your choice will appear on top
of the ALARM icon.
4. Press OK to confirm and return to MAIN MENU.
Note: When the "vibration only" mode is selected, the alarm will
not sound on the Parents Unit but it will still sound on the Nursery
Unit. When the Parents Unit is placed in the charging unit,
vibration is disabled and will temporarily change to sound alarm
only mode. During main menu and settings operations, no sound
will be transmitted to the Parents Unit but if the Sensor Pad
detects no movement, the alarm will sound. The other secondary
alarms and notifications are temporarily turned off.
• Battery capacity icon is always displayed on the LCD screen
top bar.
• When battery capacity is low - the Parents Unit will emit
a warning beep every 15 seconds, to indicate that the
batteries need to be recharged.
• Although the batteries at 1/3 capacity will support normal
operations of your monitor, it is highly recommended to
fully recharge the batteries at this stage (A).
• For FULL battery capacity, you must charge the Parents
Unit for a minimum of 10 hours in the Parents Unit cradle.
• While the Parents Unit is recharging, the battery icon will
run as shown on (B).
1. To deactivate the key tone sound, press the KEY TONE
icon.
2. Choose ON or OFF.
3. Press OK to confirm and return to the MAIN MENU.
69
E
N