4.18.
Troubleshooting
Despite high functional safety, faults can occur during use. These can have consequences in the sounder, in the oper-
ational voltage supply or in the evaluation in the control system.
It is the responsibility of the plant operator to take suitable measures to deal with occurred faults.
The first measure can be to check the operational voltage, check whether an acoustic warning signal is generated and
check the position of the alarm relay contacts, depending on the operational condition of the sounder. The cause of
the fault can thereby be traced. A step-by-step function test as described in section
'proof test' in section
4.10
If the sounder is defective, it should be repaired in the production plant. Only original replacement parts can be used
as replacements.
Faults that affect the functional safety are to be reported to the manufacturer. For a smooth process, please use the
form attached and send it to the following address.
You can reach the service or technical support on +49 (0)40 73412 -0.
4.19.
Disposal
Recycling of the device can be carried out by specialist operations. The electronics can therefore be easily removed
from the housing. The housing material is made from aluminium die casting and the magnet from ferromagnetic mate-
rial.
Should you not have an opportunity to dispose of the old device correctly, please speak to us about returns and dis-
posal.
The device at hand is not subject to the WEEE guideline 2002/96/EC and the respective national laws. The device is
only to be sent to a specialist recycling operation and not to be disposed at communal collection points
5. List of Abbreviations
DC
Diagnostic Coverage
DIP
Dual Inline Package
PFD
Probability Failure per Demand
PFH
Probability Failure per Hour
PL
Performance Level
SFF
Safety Failure Fraction
SIL
Safety Integrated Level
WEEE
Waste of Electrical and Electronic Equipment.
Datei/ file name:085501929j de-en-fr-it.docx
can also help a lot.
Post:
Pfannenberg GmbH
Service
Werner-Witt-Str.1
D-21035 Hamburg
E-Mail:
Service@Pfannenberg.com
Fax:
49 (0)40 73412-102
page 33 / 68
4.7
and carried out during the
Drwg-no.: 30007-008-12j