Suzuki DF350A Manuel Du Propriétaire page 79

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

NOTE:
• When pressing the [
limit of trolling speed of all engines, the
engine speed will not change and three long
beeps will sound.
• When pressing the [
limit of trolling speed of all engines, the
engine speed will not change and three long
beeps will sound.
• For the multiple engines:
If the button is operated when one engine
has reached the adjustment limit of trolling
speed, while any other engine has not, one
short beep sounds and the rpm of engine
which has not reached the adjustment limit
changes.
• Shift operation and throttle control remain
operational, even in troll mode.
Cancelling the Troll Mode
The troll mode can be cancelled by shifting the
all remote control levers to the neutral position,
or by increasing the engine speed to 3000 r/min
or more. In both cases, two short beeps sound
when cancelling the troll mode.
TROLL MODE SWITCH (Optional Item)
Switching to TROLL Mode
Pressing and holding the "UP" or "DN" switch
while cruising at Trolling Speed (minimum
speed), will switch the mode to TROLL Mode.
For the Trolling Speed, the desired engine
speed can be set and maintained within the
range from 600 r/min to 1200 r/min using the
[UP] button or [DN] switch.
Troll mode switch
NOTE:
Please contact your authorized Suzuki Marine
Dealer for more information.
] button at the lower
] button at the upper
Setting the Troll Mode
1. Shift into forward or reverse gear and make
sure that the throttle is fully closed (in-gear
idle speed).
2. Press the "UP" or "DN" position of the troll
mode switch, until you hear one beep. At the
same
time,
the
switches over to the TROLL Mode specific
screen and
gauge screen. When the gauge screen dis-
plays "Engine Speed Screen" or "All Items
Screen", the engine speed screen automati-
cally changes from an analog to a digital dis-
play.
NOTE:
• This system will not function properly until
engine is at normal operating temperature.
• If the switch is pressed and held while the
remote control lever is set to neutral, the
mode will not switch to TROLL Mode.
• For the multiple engines:
When the switch is pressed and held while
all the engine throttles are fully closed and
the clutch is engaged in only one of the
engines, the mode will switch to TROLL
mode.
In-gear idle speed of all engines is con-
trolled at the same time.
Multi-Function
Screen
is displayed on the
77

Hide quick links:

Publicité

Chapitres

Table des Matières
loading

Table des Matières