Suzuki DF350A Manuel Du Propriétaire page 27

Propeller removal
To remove the propeller on your outboard
motor, use the following procedure.
1. Shift to "NEUTRAL" position.
2. Remove the cotter pin 1 from the rear pro-
peller nut and remove the rear propeller nut
2.
3. Remove the washer 3, spacer 4, rear pro-
peller 5 and rear propeller stopper 6 from
the propeller shaft.
4. Straighten the locking edges on the front
propeller nut stopper 7 from the front pro-
peller nut and remove the front propeller nut
8.
NOTE:
• Front propeller nut is left hand thread.
• For removing or installing the front propeller
nut, the "Propeller nut remover & installer"
(Suzuki genuine part), is required. Consult
your authorized Suzuki marine dealer for
Suzuki genuine parts.
5. Remove the front propeller nut spacer 9,
front propeller 0 and front propeller stopper
A from the propeller shaft.
25