Alarm Management - Palazzetti Twiggy 6kW Utilisation Et Fonctionnement

6

ALARM MANAGEMENT

If a malfunction occurs, the following procedure is activated:
1)
2) one of the following system LEDs come on:
3) if the problem concerns an error, the stove will switch off.
Pressing and holding the "cancel" button
WARNING CODE
E001
Faulty control panel
E002
Remote control signal communication error
E004
Communication error
E1 01
Failed ignition error
E1 05
Pellet probe malfunction
*
E1 08 Safety error
E1 09
Pressure error or thermal safety
E11 0
Temperature probe malfunction
E111
Flue gas temperature probe malfunction
A001
Low pellet level
A002
Scheduled maintenance warning
A007
Pressure sensor malfunction
----
Clean stove
----
Failed ignition error
* Only for the models equipped with safety microswitches on the door or on the hopper lid.
After having checked the type of message, the alarm can be reset by pressing the on/off button
moments.
If the error code is "
shows the error code on the display:
DESCRIPTION
E1 09 ", before resetting the alarm, manually reset the thermostat located on the rear of the
;
POSSIBLE CAUSES
Control panel fault
Control panel fault
Connection cable between board and control panel
interrupted or detached.
the error
No pellets
Pellet quality
Faulty ignition system
Burn pot dirty
Problems with the heating system
Problems with the pump
Pellet probe disconnected or faulty
Door or hopper lid open
Seal gaskets worn
Problems with overheating in the pellet hopper
Faulty air temperature probe
Pellets running out
The stove periodically requires maintenance to be
Pressure sensor or board fault.
system dirty.
Pressure measuring tubes detached or blocked.
Combustion air intake blocked.
No pellets; Faulty ignition heater; Worn gaskets;
Incorrect burn pot position
Then the stove can be started again.
LED
for a few
25