Initial Configuration; Connection To An External Timer Thermostat - Palazzetti Twiggy 6kW Utilisation Et Fonctionnement

1 INITIAL CONFIGURATION

Before proceeding, power up the stove using the safety switch on the rear.
a) Use the arrow buttons
b) Use the button to select the password "7" and then press
c) Use the
d) Press and enter the value "54" using the
e) Press
f)
g)
h) Press
The stove will module its power according to the room temperature read by the probe on the stove.
CONFIGURATION 2

CONNECTION TO AN EXTERNAL TIMER THERMOSTAT

set temperature.
When the set temperature is reached the thermostat opens the circuit and consequently switches off the stove.
factory. Disconnect the jumper and connect the two thermostat contacts.
in "call" status. This operation is also required in the event of power failures or if the stove is switched off manually.
16
to go to the setup menu
buttons to scroll to and select submenu
to the two terminals on the board of the stove, which are jumpered in the
and then press
[3 0] --0
; "
buttons;
;
buttons;