7.4 Electrical connection
Simply connect the appliance to the electrical
system using the supplied plug (Fig. 24).
The electrical connection (plug) must be easily
accessible after appliance installation as well.
If the power supply cable is damaged
it must be replaced by the technical
assistance service or a qualified techni-
cian in order to prevent any risk.
The system must be equipped with
earthing and with a differential switch
in compliance with the laws in force.
The flue gas evacuation duct must
be equipped with its own earth
connection.
7.5 Fuel optimisation
Excellent fuel depends on different factors (type
of installation, operating and maintenance con-
ditions, type of pellets, etc.)
Upon first ignition, the stove can be regulated
for best combustion performance. Generally
speaking, if at the end of combustion, there is a
lot of residue in the burn pot, you should change
the combustion configuration (by increasing the
value) until you find the best solution.
See the function, "Fuel" in the use and operation
manual.
60
8
INITIAL
CONFIGURATIONS
Depending on the type of installation it is neces-
sary to set up the ideal configuration for correct
operation.
There are two possible configurations:
Description
Room probe (default)
Room thermostat
Fig. 24
Configuration
1
2
004778880 - 02/09/2021