Assembling the
1
Robacta PTW
1500
Fit holder, insert clamping sleeve
IMPORTANT! Insert the tungsten electrode so that the tip protrudes approx. 10
mm out of the torch body. Slightly tighten the torch cap so that the tungsten
electrode can still move inside the torch body.
3
max. 3 Nm
Assemble centring tube, plasma nozzle and
shielding gas nozzle
4
3
2
1
2
Insert tungsten electrode
IMPORTANT! Check that the tungsten
electrode is adjusted correctly (see
„Adjusting the tungsten electrode")
29