Fronius Robacta PTW 500 Instructions De Service page 28

Assembling the Robacta PTW 500, 1500, 3500
Safety
Danger from incorrect operation and work that is not carried out properly.
This can result in serious personal injury and damage to property.
▶
▶
▶
Assembling the
1
Robacta PTW
500
Insert clamping sleeve
IMPORTANT! Insert the tungsten electrode so that the tip protrudes approx. 10
mm out of the torch body. Slightly tighten the torch cap so that the tungsten
electrode can still move inside the torch body.
3
Assemble centring tube, plasma nozzle and
shielding gas nozzle
28
WARNING!
All the work and functions described in this document must only be carried
out by technically trained and qualified personnel.
Read and understand this document in full.
Read and understand all safety rules and user documentation for this device
and all system components.
1
1
2
3
2
5
4
3
2
Insert tungsten electrode
IMPORTANT! Check that the tungsten
electrode is adjusted correctly (see
„Adjusting the tungsten electrode.
1
2x360°
2
3
3