– Check beforehand whether sufficient free space for the drill
outlet is present.
– In order to prevent a running of the drill, prick punch before with hammer
and prick punch-
– Debur all drill holes and provide with rust protection.
Drill at the points drawn before a hole
of Ø 4 mm
Screw on monitor holder with the metal screws 5 x 20 mm.
Necessary parts for the attachment of the monitor holder
see
F 6 to F 8.
When attaching thread screws
The following is to be considered when making drill holes into the
plastic instrument panel.
– Check beforehand whether sufficient free space for the drill -
outlet is present.
– Pay attention that the nuts cannot pull themselves through
the intrument panel when tightening (use possibly larger washers
or sheet metal plates).
Drill at the points drawn before a drilling
of Ø 5.5 mm
Screw on the monitor holder with the thread screws 5 x 20 mm.
Necessary parts for the attachment of the monitor holder
see
F 9 to F 11. .
Execution of the break-through for the connecting cable of the
monitor.
For the execution of the connecting cable (see
possible original executions or other execution possibilities, such as
e.g. lining edges, ventilation grid or blind switch. If no openings are
available, then a hole must be drilled with Ø 18 mm. Check before
whether sufficient free space for the drill outlet is present.
A5_921-02 -GB- RV 250 neu.p65
Assembly of the monitor
39
F 12), use if
18-09-2003, 11:30
39