Festo Didactic MPS 403-1 System Notice D'utilisation page 36

403-1 System, Distributing Pro-Joining-Sorting Inline – Operating instructions
10.3 Resetting
A system's stations are always reset in the opposite order to the direction of material flow. In this case, that
would be from the Sorting Inline station to the Joining station, and finally the Distributing Pro station.
•
Turn the key actuator in the clockwise direction to the horizontal position (MAN).
The reset LED lights up.
•
Press the reset button.
•
Move the station to its initial position if necessary.
The reset LED goes out.
•
Turn the key actuator in the counterclockwise direction to the vertical position (AUTO).
The start LED lights up.
The station is ready for operation.
10.4 Starting the stations
A system's stations are always started in the opposite order to the direction of material flow, and thus in this
case from right to left. After successful resetting, press the start button at the operator panels from right to
left.
10.5 Sequence
The progress of the respective station can be interrupted at any time by pressing the black STOP switch
or the red STOP button.
1. Enter the work order in the MES computer
2. Press the start button on the Distributing Pro station
3. Workpiece with the color defined in the work order is fed out of the stacking magazine
4. Distributing Pro station conveyor motor on
5. The workpiece is stopped at the RFID read/write head for reading/writing
6. The order number and the order position are written to the RFID tag
7. Distributing Pro station conveyor motor on
8. The workpiece is transferred to the Joining station
9. The workpiece is detected at the Joining station
10. Joining station conveyor motor on
11. The workpiece is detected at the start of the Joining station's conveyor
12. Distributing Pro station conveyor motor off
13. The workpiece is stopped at the first RFID read/write head at the Joining station for reading/writing
14. The RFID tag is read
36
NOTE
© Festo Didactic 8129446