Wilo Yonos GIGA2.0-I Notice De Montage Et De Mise En Service page 152

en
9.4.8 Main menu "Settings"
Settings
Control settings
External interfaces
Dual pump management
Fig. 35: Settings menu
152
Commissioning
Universal Display text
Setpoint = Setpoint =
2
1.1.3 Kp Parameter Kp
2
1.1.4 Ti Parameter Ti
2
1.1.5 Td Parameter Td
2
1.1.6 Control inversion
OFF Inversion OFF
ON Inversion ON
1.1.7 Emergency operation
OFF Pump OFF
ON Pump ON
3
1.1.8 Emergency operation speed
1.1.9 Setpoint source
1.1.9 / 1 Internal setpoint
1.1.9 / 2 Analogue input (AI2)
1.1.9 / 3 CIF module
4
1.1.10 Substitute setpoint
1.1.15 Pump ON/OFF
OFF Switched off
ON Switched on
1.3 External interfaces
1.4 Dual pump management
1.5 Display settings
1.6 Additional settings
1
According to the currently set control mode, only the corresponding setpoint opens.
2
The menu item only opens if the PID control mode is set.
3
The menu item only opens if emergency operation is set to "ON".
4
The menu item only opens if analogue input AI2 is selected as the setpoint source.
Different settings can be changed in the "Settings" menu
The "Settings" menu is selected by turning the operating button to the "gear wheel"
symbol .
Confirm the selection by pressing the operating button. Selectable submenus open.
Select a submenu by turning the operating button to the right or left. The selected sub-
menu item is highlighted in colour.
Press the operating button to confirm the selection. The selected submenu or down-
stream settings dialogue appears.
NOTICE
If there are more than three submenu items, this is indicated by an arrow
or below the visible menu items. Turn the operating button in the corresponding dir-
ection to open the submenu items on the display.
2
2
2
2
3
4
.
1
above
WILO SE 2022-05