Care Of Glass; Care Of Plated Parts; Blower Service Or Replacement - Napoleon TIMBERWOLF EPI22 Instructions D'installation Et D'opération

7.7

CARE OF GLASS

If the glass is not kept clean permanent discolouration and / or
blemishes may result. Normally a hot fi re will clean the glass.
The most common reasons for dirty glass include: not using
suffi cient fuel to get the appliance thoroughly hot, using green
or wet wood, closing the draft so far that there is insuffi cient air
for complete combustion.
If it is necessary to clean the glass, buff lightly with a clean dry
cloth and non-abrasive cleaner.
DO NOT CLEAN GLASS WHEN HOT! Clean the glass after the fi rst 10 hours of operation with a
recommended appliance glass cleaner. Thereafter clean as required.
The glass is very strong but do not let burning fuel rest or fall against it and always close the door gently.
NEVER FORCE IT SHUT!
If the glass should ever crack or break while the fi re is burning, do not open the door until the fi re is out and do
not operate the appliance again until the glass has been replaced, available from your Authorized dealer. DO
NOT SUBSTITUTE MATERIALS.
7.8

CARE OF PLATED PARTS

If the appliance is equipped with plated parts, you must clean fi ngerprints or other marks from the plated
surfaces before operating the appliance for the fi rst time. Use a glass cleaner or vinegar and towel to clean.
If not cleaned properly before operating for the fi rst time, the marks can cause permanent blemishes on
the plating. After the plating is cured, the fi ngerprints and oils will not affect the fi nish and little maintenance
is required, just wipe clean as needed. Prolonged high temperature burning with the door ajar may cause
discolouration on plated parts.
NOTE: The protective wrap on plated parts is best removed when the assembly is at room
temperature but this can be improved if the assembly is warmed, using a hair dryer or similar heat
source.
7.9

BLOWER SERVICE OR REPLACEMENT

A. Turn off all electrical power to the
appliance.
B. Remove the two screws securing the
cover to the blower housing.
C. Remove ground wire screw.
D. Remove the four screws securing the
retainer and lift the retainer/blowers up
and out of the housing.
E. Dust and debris may accumulate,
vacuum the blowers and housing prior to
re-installation.
F. If blower replacement is required, each
blower is attached to the retainer by four
screws. Remove the screws to replace
or repair.
G. Re-install by reversing the procedure.
COVER
RETAINER
GROUND
WIRE
WARNING
!
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
5.3
6.1
W415-1466 / 04.21.15
25
EN