Door Removal; Glass Replacement - Napoleon TIMBERWOLF EPI22 Instructions D'installation Et D'opération

24
7.5

DOOR REMOVAL

EN
BURNING YOUR APPLIANCE WITH THE DOORS OPEN OR AJAR CREATES A FIRE HAZARD THAT
Pivot the door open and lift the door and pins off the bushings. Set the door aside being
careful not to scratch the paint.
7.6

GLASS REPLACEMENT

CARE MUST BE TAKEN WHEN REMOVING AND DISPOSING OF ANY BROKEN DOOR GLASS OR
DAMAGED COMPONENTS. BE SURE TO VACUUM UP ANY BROKEN GLASS FROM INSIDE THE
DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASS
1. When the appliance is cool, remove the door
and place it face down on a soft surface Be careful
not to scratch the paint.
2. Remove the 5 screws securing the
glass retainers. Remove all broken glass
3. Cut the 3/4" (19mm) fl at gasket into 3 1/2" (89mm)
lengths and affi x to glass retainers as illustrated,
ensure the gasket extends past the ends of the
retainers by 1/4" (6.3mm).
4. Apply small beads of silicone in the gasket groove,
as shown.
5. Place the rope gasket in the gasket groove, on top
of the silicone.
6. Place the glass on the door. Re-install the glass
retainers.
NOTE: For replacement glass, size, thickness and
specifi cations see "REPLACEMENTS" section.
W415-1466 / 04.21.15
!
MAY RESULT IN A HOUSE AND OR CHIMNEY FIRE.
DO NOT STRIKE OR SLAM DOOR.
NEVER REMOVE THE DOOR WHEN THE APPLIANCE IS HOT.
!
DO NOT USE SUBSTITUTE MATERIALS.
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
APPLIANCE BEFORE OPERATION.
REMOVED, CRACKED, BROKEN OR SCRATCHED.
WARNING
WARNING
56.2
¾" x 3 ½"
FLAT
GASKET
¼" ROPE
GLASS
GASKET
SILICONE