Re-Arming - Mustang Survival MINIMALIST BELT PACK Manuel De L'utilisateur

RE-ARMING

To re-arm your flotation device, you will need Mustang Survival's Re-
Arm Kit J (MA3070). The spent inflation parts will first be removed,
and replacement parts will be installed. The re-arm kit includes:
• 16g CO cylinder
2
• Ready status indicator pin
1. Place your flotation device on a flat surface with the bladder
unfolded.
2. Deflate using the oral tube (see Fig. 11).
3. Remove the cylinder by rotating counterclockwise and then pull
out (see Fig. 13). Discard the used cylinder.
REMOVE THE CYLINDER
FIGURE 13
4. Check the manual inflation system to determine that the lever
arm and piercing pin move freely when moving the lever
(attached to the pull tab) several times down and up. There
should be no binding of mechanical parts.
5. Position lever arm (see Fig. 14).
POSITION LEVER ARM
FIGURE 14
OK
10