Re-Arming Your Pfd (Md2015) - Mustang Survival MD2015 Manuel D'utilisation

3. Examine the service indicator (Fig. 1). If the service indicator is
red, the mechanism has been fired or is incorrectly fitted and the
inflator requires service (see "Re-arming Your PFD (MD2015)" on
page 7 or see "Re-arming Your PFD (MD2017)" on page 9).
THE SERVICE INDICATOR MUST BE GREEN BEFORE PROCEEDING.
4. Your device is ready to be repacked (see "Repacking" on page 12).

RE-ARMING YOUR PFD (MD2015)

A RE-ARM KIT (MA2014) IS REQUIRED FOR THIS PROCEDURE.
FOLLOW INSTRUCTIONS IN THE EXACT SEQUENCE BELOW.
1. Unpack or open the Inflatable PFD so that the manual inflator is
exposed (Fig. 7).
2. Remove the cylinder/bayonet assembly by rotating counter-
clockwise and then pull out. Discard the used cylinder/bayonet
assembly.
3. Check the new cylinder/bayonet assembly to ensure the o-ring is
in place and the sensor ring is attached (Fig. 7). Ensure that the
CO cylinder has not been pierced (Fig. 10).
2
4. Raise, and hold, the lever into the inflator housing. Install a new
cylinder/bayonet assembly by engaging bayonet tabs in housing,
pushing in then turning clockwise 1/8 turn to a full stop (Fig. 8).
PFD WILL ONLY INFLATE IF CYLINDER IS TURNED TO A FULL STOP.
5. Examine the service indicator (Fig. 8) and ensure it is GREEN. If
the service indicator is red, the mechanism has been fired or is
incorrectly fitted and the inflator requires service.
THE SERVICE INDICATOR MUST BE GREEN BEFORE PROCEEDING.
6. Refold the Inflatable PFD in accordance with the Repacking
section (see "Repacking" on page 12).
YOUR INFLATABLE PFD (MD2015) IS NOW READY FOR MANUAL USE
7