Re-Arming Your Manual Pfd (Md2951) - Mustang Survival DLX38 Guide D'utilisation

RE-ARMING YOUR MANUAL PFD (MD2951)

NOTE: A RE-ARM KIT (MA7114) IS REQUIRED FOR THIS PROCEDURE.
IMPORTANT: FOLLOW INSTRUCTIONS IN THE EXACT SEQUENCE BELOW.
1. Unpack or open the Inflatable PFD so that the inflator is exposed
(Fig. 13).
2. Remove the cylinder/bayonet assembly by rotating counter-
clockwise and then pull out. Discard the used cylinder/bayonet
assembly.
3. Check the new cylinder/bayonet assembly to ensure the o-ring is
in place and the sensor ring is attached (Fig. 16). Ensure that the
CO cylinder has not been pierced (Fig. 16).
2
Service
Indicator
Step 5
SERVICE INDICATOR:
If green, unit is operable
If red, stop and service unit
Fig. 13
12
MUSTANG SURVIVAL/ OWNER'S MANUAL – DLX 38 INFLATABLE PFD
MD2951 Manual Inflator
Cylinder
Step 2
Sensor Ring
Step 3
Bayonet
Tab
Step 4
O-Ring
Step 3
Lever