Femi XXX EVO ALU Instructions Pour L'utilisation Et L'entretien page 43

5. MAINTENANCE - STORAGE - ASSISTANCE - DISPOSAL
NOTES
Routine maintenance operations which can be performed by the user are described
below.
For other interventions or extraordinary maintenance operations, please contact an
authorized after sales service.
DANGER - WARNING
BEFORE PERFORMING ANY MAINTENANCE WORK, PLACE THE MACHINE
IN SAFETY CONDITIONS AS DESCRIBED IN HEADING "GENERAL SAFETY
REGULATIONS".
5.1. INSTRUCTIONS FOR REPLACING THE SAW BLADE (Fig. 13)
DANGER - WARNING
WEAR PROTECTIVE GLOVES.
Tools required
- For some models, 2 Allen keys for 6 mm socket head screws (CEI6).
- For some models, 1 Allen key for 6 mm socket head screws (CEI6) and a 13 mm hex wrench
(CEI13).
Check the compatibility of the NEW blade
The characteristics of the blade must be compatible with the technical specifi cations indicated
in the relative appendix.
DANGER - CAUTION
It is strictly forbidden to use high speed steel blades.
Check the compatibility of the USED blade (Fig. 14A Fig. 14B)
NOTES
Use of used blades is not recommended.
However, in the case of necessity, check that the blade is intact and shows no signs of
wear.
a. Lift the upper surface to its maximum height (see heading "SET-UP IN CIRCULAR SAW
MODE").
b. Press catch (36) and release the guard (11) by lifting it.
c. Insert a CEI6 in the end (37) of the drive shaft.
DANGER - WARNING
SCREW (38) HAS A LEFT-HAND SCREW THREAD
EN
Cont....
37