Operation Environment; Guarantee - Metrix AX 1360P Notice De Fonctionnement

General Instructions (contd.)
Operation
Environment
Definition of
measurement
categories

Guarantee

I - 30
•
Location: Indoor, no direct sunlight, dust free, almost non-conductive
pollution (note below)
•
Relative Humidity: < 80%
•
Altitude: < 2000m
•
Temperature: 0 to 40°C
(Pollution Degree) IEC 61010-1: specifies the pollution degrees and their
requirements as follows. The instrument falls under degree 2.
Pollution refers to "addition of foreign matter, solid, liquid, or gaseous
(ionized gases), that may produce a reduction of dielectric strength or
surface resistivity".
Pollution degree 2: Normally only non-conductive pollution occurs.
Occasionally, however, a temporary conductivity caused by condensation
must be expected.
Overvoltage category ll is for equipment intended to be supplied from the
building wiring. It applies both to plug-connected equipment and to
p ermanently connected equipment.
Overvoltage category lll is for equipment intended to form part of a
building wiring installation. Such equipment includes socket outlets, fuse
p anels, and some mains installation control equipment.
Overvoltage category lV is for equipment installed at or near the origin of
the electrical supply to a building, between the building entrance and the
main distribution board. Such equipment may include electricity tariff
meters and primary overcurrent protection devices.
This equipment is guaranteed for all manufacturing and parts defects in
compliance with the general terms and conditions which are available on
r equest
During the1 year guarantee period, the instrument may only be repaired by
the manufacturer who reserves the right to make the decision to either
repair or replace all or part of the appliance. In the event of a return of the
equipment to the manufacturer the shipping charge from the customer to the
m anufacturer is at the customer's expense.
The guarantee does not apply in the following conditions:
•
inappropriate use of the equipment or use with incompatible equipment
•
one or more changes made to the equipment without prior explicit
•
authorisation from the manufacturer's technical department
•
an intervention is made on the instrument by a person not approved by
the manufacturer
•
the adapting to a specific application that is not part of the definition of
the instrument or in the operating guide
•
damage caused by a mechanical shock, by dropping the instrument or
by flooding.
General instructions
DC Power Supply