General Instructions; Introduction; Precautions; Safety Measures - Metrix AX 1360P Notice De Fonctionnement

General instructions

General Instructions

Introduction

Precautions

Safety measures

Power supply
Symbols on the
instrument
Fuse
DC Power Supply
You have just purchased an AX 1360P Multi-channel Programmable DC
Power Supply and we appreciate your confidence.
To obtain the best service:
- read this notice carefully,
- respect the safety instructions.
Failure to respect the warnings and/or usage instructions may damage the
device and/or installations and may be dangerous for the user.
•
Before plugging into local AC mains, check and make sure that the
output voltage is compatible to the load. (It is suggested to disconnect a
load before plugging into local AC mains).
•
The max. output voltage of the instrument may be over 60V
current 6A avoid touch the metal contact part of the output terminals.
•
Do not use the instrument in a dusty place or a highly humid place as
such will cause instrument reliability degradation and instrument
failures.
•
Install the instrument in a place where the ambient temperature is in
range of -10~70° C. Note that the instrument operation may become
unstable if it is operated in an ambient temperature exceeding the
range of 0~40° C.
•
Do not obstruct the ventilation holes.
•
Only use with safety leads, diameter of which is appropriated to output
current.
AC Input voltage: 220 V ± 10 %, 50/60Hz, 500 VA max.
Connect the protective grounding conductor of the AC power cord to an
earth ground to avoid electrical shock.
Warning: potential hazard, refer to the user's manual.
Selective waste sorting for recycling electric and electronic waste.
In compliance with the WEEE 2002/96/EC directive:
the device should not be considered as household waste.
Earth terminal
Fuse
USB host
European conformity
•
Fuse type: 220V/230V: T3.15 A / 250 V, 5 x 20 mm
•
Make sure the correct type of fuse is installed before power up.
•
Replace the AC fuse with the same type and rating as the original fuse.
•
Disconnect the power cord before fuse replacement.
•
Make sure the cause of fuse blowout is fixed before fuse replacement.
and
DC
I - 29