Loading Rechargeable Battery Data - VOLTCRAFT V-CHARGE 100 DUO Notice D'emploi

c) Loading Rechargeable Battery Data
• Select the function "BATT MEMORY" in the main menu
of the charger with the button "INC" or "DEC".
• Confirm the selection by pressing the "START/ENTER"
button. The memory number flashes.
• Select one of the 10 memories with the buttons "INC" or
"DEC".
If there are data in the memory, the display will
show in the bottom line alternately, e.g., the re-
chargeable battery type and the cell number, as
well as the charging and discharging current.
When the memory is empty, the bottom line
shows only "ENTER SET ->".
• Load the battery data from the selected memory by
pushing the button "START/ENTER" for 3 seconds.
The display shows the message "ENTER CHARGE
LOAD....."; the data are then loaded and the desired
charging/discharging programme can then be started
(push the button "START/ENTER" again for 3 sec-
onds).
If you keep the button "START/ENTER" pushed for 3 seconds in an empty memory,
the charger will start selection/setting mode, see chapter 14. a).
106
[ BATT MEMORY 1]
LiPo 7.4V(2S)
[ BATT MEMORY 1]
C:2.2A D:1.0A
[ BATT MEMORY 2]
ENTER SET->
ENTER CHARGE
LOAD...